How to knit Fair Isle
Fair Isle is knitting with two colors in a row. You knit with one, carry the other loosely behind the work, and swap as the chart tells you. It looks complicated and is mostly a matter of rhythm.
What makes knitting Fair Isle
Fair Isle comes from Shetland and has a few habits that set it apart from other colorwork. Each row or round uses only two colors. The motifs are small, so the unused color never travels far. And the colors change from band to band, often shading from dark to light, which is how a sweater ends up with a dozen shades while you never hold more than two at once.
It is traditionally knit in the round, so the right side always faces you and every round is read from right to left. Armholes and necks are knit straight through and cut open later, a technique called steeking.
What you need
A first project such as a hat or a cowl needs very little:
- Two colors of fingering or jumper-weight wool with good contrast. Woolly, slightly sticky yarns such as Shetland are the most forgiving: the stitches grip each other and uneven tension evens out when you block.
- A circular needle around 3 mm (US 2.5) for the colorwork, and often a size smaller for the ribbing.
- A chart. Small repeats of 4 to 8 stitches are easiest to memorise; the Fair Isle chart maker has several to start from.
Avoid superwash and very smooth yarns for a first try. They are slippery, so loose floats and uneven stitches stay visible after blocking.
Holding two colors
There is no single right way. Pick the one that feels least awkward and stick with it for the whole project:
- 1One color in each hand: the background yarn in your right hand (thrown, English style) and the pattern yarn in your left (picked, continental style). This is the fastest once it clicks.
- 2Both colors in your right hand, over different fingers, throwing whichever the chart asks for.
- 3Both colors in your left hand, over the index finger, picking one or the other.
- 4One color at a time: drop one yarn and pick up the other at every change. Slow, but a fine way to learn how the fabric is built.
Whichever you choose, keep each color in the same position for the whole piece. The yarn that comes from underneath at each change, usually the one held in the left hand, makes slightly bigger stitches and looks more prominent. Most knitters make the pattern color the dominant one.
Keep your floats loose
The strand carried behind the work is a float. If it is pulled tight, the fabric puckers and loses its stretch. Before you change colors, spread the stitches you have just knit out along the right needle so they sit at their natural width, then bring the new color across. The float should lie flat against the back without pulling.
Knitting colorwork inside out, with the floats on the outside of the tube, is a simple trick for loose floats: they have to travel the longer way around.
When a color is not used for more than about five stitches, catch the float so it doesn't snag. See how to catch floats for the methods.
Reading the chart
Start at the bottom right corner and read every round from right to left (more in how to read a knitting chart). A chart usually shows one repeat; you work it again and again around the needle. Place a stitch marker between repeats so a mistake can never travel further than one repeat.
Check the colors in each row before you start it. If a row uses three colors, that is a deliberate choice by the designer and is usually only a stitch or two.
Block it
Fresh colorwork often looks lumpy. Soak the finished piece in lukewarm water for twenty minutes, press out the water in a towel and lay it flat or on a form to dry. The wool relaxes, the stitches even out and the floats settle into place. Blocking does more for Fair Isle than for almost any other knitting.
Questions
Can I knit Fair Isle flat?
Yes. On wrong-side rows you purl with both colors held, reading the chart from left to right. It is slower than knitting in the round, so many knitters prefer to knit flat pieces in the round and steek.
How many colors can a Fair Isle project have?
As many as you like in total, but only two in any one row. Changing the background and pattern colors between bands is what gives Fair Isle its shaded look.
What is the best yarn for Fair Isle?
Traditional Shetland jumper-weight wool, knit at about 28 to 32 stitches per 10 cm. Its grip hides small tension differences and makes steeking safe.